Krone Swadro 810, Operating Instructions Manual, Page: 15 / 64

II - 3
16. After removing the PTO shaft, attach the protective
cover to the PTO shaft end!
17. If damage occurs, correct this immediately before using
the implement!
2.3.3 Hydraulic System
1. The hydraulic system is pressurized!
2. When connecting hydraulic cylinders and
engines, make sure that the hydraulic hoses are
connected correctly!
3. When connecting the hydraulic hoses to the tractor
hydraulics, make sure that the hydraulics of both the
tractor and the implement have been depressurized!
4. In the case of hydraulic connections between tractor and
implement the coupling sleeves and plugs should be
marked to ensure a proper connection! If the connections
are switched, the function will be reversed (e.g. raising/
lowering) - danger of accidents!
5. Check the hydraulic hose lines at regular intervals and
replace them if damaged or worn! The new hoses must
fulfill the technical requirements set by the manufacturer
of the implement!
6. When searching for leaks, use suitable aids to avoid the
risk of injuries!
7. Liquids escaping under high pressure (hydraulic oil) can
penetrate the skin and cause serious injury! Seek
medical help immediately should injuries occur! Risk of
infection!
8. Before working on the hydraulic system, lower the
implement, depressurize the system and switch off the
engine!
2.3.4 Tyres
1. When working on the tyres, make sure that the
implement has been safely lowered and secured
against rolling (wheel chocks).
2. Installing wheels and tyres requires adequate
knowledge and suitable tools!
3. Repair work on the tyres and wheels should be done
by specially trained personnel using appropriate
installation tools only!
4. Check tyre pressure regularly! Inflate the tyres to the
recommended pressures!
2.3.5 Maintenance
1. Repair, maintenance and cleaning work as well as
the rectification of malfunctions may only ever be
carried out when the drive is switched off and the
engine is at a standstill!
- Remove the ignition key! Pull the parking brake
for the balancing weight.
2. Regularly check that nuts and bolts are properly
seated and tighten if necessary!
3. When doing maintenance work to a raised implement,
always use suitable means to secure it against
falling.
4. When replacing working tools with cutting edges, use
suitable tools and gloves!
5. Dispose of oils, greases and filters according to
regulations!
6. Always disconnect the power supply before working
on the electrical system!
7. If protective devices and guards are subject to
wear, check them regularly and replace them in
good time!
8. When doing electrical welding on the tractor and
attached implements, disconnect the alternator
and battery cables!
9. Replacement parts must at least comply with the
technical requirements set by the manufacturer of
the implements!
This is guaranteed when using genuine KRONE
replacement parts!
10. Only use nitrogen for filling pneumatic
accumulators - Risk of explosion!