Krone Swadro 700, Operating Instructions Manual, Page: 15 / 64

II - 3
13. Cau1tion! The flywheel will continue to rotate for some
time even after the PTO shaft has been disengaged!
Keep clear of the implement during this time. Do not do
any work on the implement until the machine has come
to a complete stand-still and the flywheel has been
secured using the hand brake.
14. Disengage the PTO shaft, stop the engine and remove
the ignition key before cleaning, lubricating and adjusting
the PTO shaft driven implements or the PTO shaft!
Secure the flywheel with the hand brake.
15. Place the disconnected PTO shaft onto the bracket
provided!
16. After removing the PTO shaft, attach the protective
cover to the PTO shaft end!
17. If damage occurs, correct this immediately before using
the implement!
2.3.3 Hydraulic System
1. The hydraulic system is pressurized!
2. When connecting hydraulic cylinders and
engines, make sure that the hydraulic hoses are
connected correctly!
3. When connecting the hydraulic hoses to the tractor
hydraulics, make sure that the hydraulics of both the
tractor and the implement have been depressurized!
4. In the case of hydraulic connections between tractor and
implement the coupling sleeves and plugs should be
marked to ensure a proper connection! If the connections
are switched, the function will be reversed (e.g. raising/
lowering) -
danger of accidents!
5. Check the hydraulic hose lines at regular intervals and
replace them if damaged or worn! The new hoses must
fulfill the technical requirements set by the manufacturer
of the implement!
6. When searching for leaks, use suitable aids to avoid the
risk of injuries!
7. Liquids escaping under high pressure (hydraulic oil) can
penetrate the skin and cause serious injury! Seek
medical help immediately should injuries occur! Risk of
infection!
8. Before working on the hydraulic system, lower the
implement, depressurize the system and switch off the
engine!
2.3.4 Tyres
1. When working on the tyres, make sure that the
implement has been safely lowered and secured
against rolling (wheel chocks).
2. Installing wheels and tyres requires adequate
knowledge and suitable tools!
3. Repair work on the tyres and wheels should be done
by specially trained personnel using appropriate
installation tools only!
4. Check tyre pressure regularly! Inflate the tyres to the
recommended pressures!
2.3.5 Working in the Vicinity of Power
Transmission Lines
1. Always take great care when working under or in
the vicinity of power transmission lines.
2. When transporting the machine during operation,
make sure that the total height does not exceed
3.5 m.
3. If there is any need to travel under overhead lines,
the machine operator must request information on
the rated voltage and the minimum height of the
overhead lines from the overhead line operator.
4. Always keep the safe distances according to the
table.
Rated voltage Safe distance from
overhead lines
kV m
to 1 1
Above: 1 to 110 2
Above: 101 to 220 3
Above: 220 to 380 4