Summary of how to Operate a Single Machine
3
Control the
VS-1616V
:
Using the front panel buttons
Remotely, by RS-485 or RS-232 serial commands transmitted by a touch
screen system, PC, or other serial controller
Remotely, from the Kramer
IR-1
Infra-Red Remote Control Transmitter
Via external dry-contact push buttons
To achieve the best performance:
Connect only good quality connection cables, thus avoiding interference,
deterioration in signal quality due to poor matching, and elevated noise levels
(often associated with low quality cables)
Avoid interference from neighboring electrical appliances that may
adversely influence signal quality and position your Kramer
VS-1616V
in a
location free from moisture and away from excessive sunlight and dust
4 Summary of how to Operate a Single Machine
By default, the
VS-1616V
is setup for use as a single machine.
This means that it is:
A 16x16 composite video switcher
Switched during the vertical interval of the external reference
In particular, be sure that the dipswitches are set as Figure 1 illustrates (see
section 6.5 for further details):
Figure 1: Dipswitch Setup on a Single Machine
To operate a single machine, see Table 1.
