MENU Commands Sequence
41
VIDEO FORMAT setting
yes -> TAKE, next -> MENU
2. Press the
TAKE
button.
The Displays show the messages:
Use OUTkey to configure
1: CV 2: YC 3: YUV 4: RGBS
current: 1: CV
1
3. Press the appropriate
2
OUT
button
#
2
,
3
or
4
3
.
The MATRIX Display shows the message:
Press TAKE to configure
for x
Where x is the new VIDEO FORMAT setting, either Y/C, YUV or RGBS
(At this stage, you can still configure a different video format by pressing
another
OUT
button). To exit the VIDEO FORMAT setting command,
press a non-relevant button, for example, an IN button.
4. Press the
TAKE
button again.
The Displays show the messages:
FORMAT changed!
All INs/OUTs reset
current: 1: x
Where x is the new VIDEO FORMAT setting, either Y/C, YUV or RGBS
8.4 Setting the MACHINE ADDRESS
Press the MENU button until you reach the Setting the MACHINE
ADDRESS command. Choose the stand alone or the large matrix
setting.
You set the MACHINE ADDRESS using the OUTkeys # 1 to 9, and 10 (for
0). The OUTkeys function on a decimal-basis, and not on a positional-basis.
For example, to enter the # 15, press # 1 followed by # 5 (not # 15).
You can change the MACHINE ADDRESS from:
The stand alone setting to a large matrix setting (see section 8.4.1)
A large matrix setting to the stand alone setting (see section 8.4.2)
A large matrix setting to a large matrix setting with a different
MACHINE ADDRESS (see section 8.4.3)
1 If currently configured for composite (CV)
2 Depending on the required video format
3 Pressing OUT button # 1 when the machine is already configured for composite (CV) will show the message: requested the
same format NO CHANGES made
