KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting the VP-81SID 8x1 Digital STEP-IN Switcher
12
4. Connect the TP OUT RJ-45 connector to a compatible TP receiver up to 50m
(164ft), for example,
PT-572+
.
5. Connect the S/PDIF RCA digital audio output to an audio acceptor (for
example, a DAT recorder).
6. Connect the balanced audio 5-pin terminal block (see
Section 6.1
) to an audio
acceptor (for example, a balanced stereo audio amplifier).
7. Optional—Connect up to ten remote, contact closure input selection switches
to the REMOTE terminal block (see
Section 6.2
).
8. Optional—Connect the Ethernet RJ-45 TP port directly or via a LAN to a PC
controller.
Alternatively, you can connect a PC and/or controller to the:
RS-232 port (see
Section 6.3
)
RS-485 port (see
Section 6.4
)
9. Connect the power cord
1
.
Note
: When signal sources are disconnected from inputs, signal acceptors (for
example, a projector) may not go into standby mode automatically. We therefore
recommend that you turn off the
VP-81SID
and/or the acceptor.
Note
: When using the
PT-572+
in conjunction with the
VP-81SID
do not connect
the 12V power supply to the
PT-572+
.
6.1 Connecting to a Balanced Audio Acceptor
Figure 4
illustrates how to wire devices to the balanced audio output.
Figure 4: Balanced Stereo Audio Output Connection
6.2 Connecting Remote Contact Input and Output Selection Switches
You can connect remote, contact closure input selection switches to the REMOTE
terminal block on the rear panel of the
VP-81SID
. Remote input selection switches
provide the ability to remotely activate the inputs and an output.
Table 3
lists the remote contact terminal block connections.
1 We recommend that you use only the power cord that is supplied with the device
im Vertrieb von CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203
