42
VP-553 - Using the Embedded Web Pages
The USB Routing page also lets you tie any of the USB ports to any of the
switcher/scaler inputs that are routed to output 1. To do so click the
Tie To Input
button and then assign the USB 1 to 4 ports each to one of the inputs. In the
example in
Figure 35
(if the Tie To INPUT button was selected) USB 1 is tied to
HDMI 1, USB 2 is tied to HDMI 2 and so on.
Figure 35: The USB Tied to a Selected Input
7.6
The Audio Settings Page
The audio settings page lets you define the audio parameters for the inputs, outputs
(1 and 2), and the audio out (Monitor and Line out).
The main page lets you switch and set the selected audio signal to the two outputs
and the independent audio output. The rear panel DIP-switch settings (see
Figure
2
): Auxiliary Settings, Stereo/Mono and Microphone, are displayed.
Note that the DIP-switch settings cannot be changed via the Web pages only
physically on the rear panel.
The Input tab (see
Figure 36
) lets you set the volume individually for each input,
including the analog and embedded audio HDMI signals.