Kramer Electronics Ltd.
FC-7P
– Kramer Protocol 3000
31
Spaces between parameters or command terms are ignored.
Entering Commands
You can directly enter all commands using a terminal with ASCII communications software,
such as HyperTerminal, Hercules, etc. Connect the terminal to the serial or Ethernet port on
the Kramer device. To enter
CR
press the Enter key.
(
LF
is also sent but is ignored by command parser).
For commands sent from some non-Kramer controllers like Crestron, some characters require
special coding (such as, /X##). Refer to the controller manual.
Command Forms
Some commands have short name syntax in addition to long name syntax to allow faster
typing. The response is always in long syntax.
Chaining Commands
Multiple commands can be chained in the same string. Each command is delimited by a pipe
character (“|”). When chaining commands, enter the
message starting character
and the
message closing character
only once, at the beginning of the string and at the end.
Commands in the string do not execute until the closing character is entered.
A separate response is sent for every command in the chain.
Maximum String Length
64 characters