Aileron
Assembly left aileron as sketched above. Carbon spar should be centered in the middle.
Don't forget to insert aileron_horn_L part into aileron_L_1 when leading spar through. When all the
parts are on their position, put glue on contact points where carbon spars are touching printed parts.
Wing
Some hinge slots are not deep enough to fit whole hinge length. Shorten all
hinges as shown on the picture. It has no benefit in terms of added stiffness
of rigidity to use whole hinge arm length as only small hinge area is in
contact with the wing.
Be careful when using glue near pinned part of the hinge. First insert the hinge into hinge hole and
then apply the glue from inner side of the wing. Do the same when gluing aileron to hinge. First
insert all hinges into hinge holes on aileron and then apply glue from inner side of aileron. Make
sure that aileron has enough space for moving from every side.