Fuselage step 1
Remove Y-shaped printing support from fuse_4 part.
Round the ends of carbon spars to make them slide easily into spar leading holes. Remember to use
breathing mask to avoid inhaling carbon dust whenever sanding carbon! Test fit all 4 spars into
fuse_0. It is important to push them all the way in. The longer spars (fuse_spar_2x1_868) should be
on the bottom side.
Now take out all 4 spars and put glue into spar leading holes
that are touching motor mount plate (as shown on right
picture). Quickly insert spars back into fuse_0. This is the only
time that glue is used before carbon spars are on their position
and it has to be done to make motor mount as strong as
possible.
When spars are on their position apply more glue from inner
side of fuse_0. There are spaces along spar leading tubes
where you can put the glue and let it leak further into places which are hard to reach.
You can continue with rest of fuse parts. Always put each part on its position and only then apply
the glue from inner side. If glue is applied before carbon spar is inserted into the part glue could
cure before the part is on its position.
Depending on your servo choice use servo_plate_hs_65 or customized servo_plate_generic part.
First insert fuse_servo_plate_spar_2x1_68 into servo_plate, center it and glue it in place.
Put servo mount plate into fuse_3. Apply the glue also to the servo plate leg to secure it in place.