KPWL-0300 User's Manual
16
6.1 Procedure to Change Settings
This section explains how to change settings using the KPWL-0300 web screen.
Step
1: Prepare the necessary equipment
□
LAN cable (
cross cable
) ………… 1
A cross cable is required to connect the KPWL to a computer.
(If the computer you are using supports Auto-MDI, connection using a standard straight LAN
cable is also supported.)
□
KPWL unit and its AC power cable
* Installation of an antenna is not required just to configure settings. Install an antenna for
connection testing and to check the radio wave intensity.
□
Computer for configuring settings: Use a computer that has a wired LAN port* and web browsing capabilities.
* If a there is no wired LAN port, use a USB-wired LAN adapter, etc.
* The explanation here uses a computer running Windows 7, with
the Internet Explorer 8.0 web browser.
Step
2: Connect the KPWL-0300 unit to the computer
(1) Power up the KPWL unit (connect the AC power cable). Next, connect one end of the LAN cable to the
computer's LAN port and then connect the other end to the KPWL unit's LAN port.
(2) Configure the computer's internet settings.
1. In Control Panel, click "Network and Internet" and then click "Network and Sharing Center."
2. Click "Local Area Connection." On the Local Area Connection Status dialog box that appears, click [Properties].
3. In the list that appears, select "Internet Protocol Version 4 (TCP/IPv4)" and then click [Properties].
4. Select the "Use the following IP address:" option and then input the IP address and subnet mask shown below.
IP Address
192.168.3.x (x = 2 to 255)
Subnet Mask
255.255.255.0
*
Take a screen shot of or otherwise record the original IP address and subnet mask settings so you can restore them when
necessary.
5. After inputting the settings, click [OK] to close the dialog box.
6. Click [Cancel] on the Local Area Connection Properties dialog box, and then click [Close] on the Local Area Connection
Status dialog box.
