Kortek corporation
57
of
99
PDP R&D Center
5. Remove four large screws from the rear side of the display.
6. Insert the bolts and insulation rubber into the place from which the four large screws have been removed
as shown in the following figure:
7. Put the insulation rubber point protruding from the rear top of the display in the groove on the top of the
wall attachment panel. Lift up the display a little bit so that the insulation rubber point at the bottom of the
rear side of the display is put in the groove at the bottom of the wall attachment panel(Do not lift the
display with any pressure. The insulation rubber at the top may be taken off.)