Kortek corporation
56
of
99
PDP R&D Center
7.2.3 Installing the Display on the Wall Attachment Panel:
1. Check for the stability of the wall where the PDP is to be installed. If the wall is not enough strong to
support the PDP, strengthen the wall before installation.
2. Fix the volt of Anchor on the wall as shown in the following figure
3. Fix the wall attachment panel on the wall by putting nuts on volts as shown in the following figure.
4. Using the wall attachment panel, you may adjust the angle of the display from 0 to 20 degrees. The angle
can be set in 5 degrees of distance each using the angle control holes on the sides of the panel.