Page 20
Version 02-2010
Compakt-Comfort-2
Operation
Stopping
Press the rocker switch in the opposite direction until the
machine stops moving
or
press the STOP pushbutton – the machine
is brought slowly to a halt
or
release the clutch/safety stop lever (EMERGENCY STOP) - the
drive is stopped immediately!! The actuating cylinder on the pump
returns automatically to the 0 position. The LED on the rocker
switch must light up green.
4.
Clutch/safety stop lever
Caution!
Use the clutch/safety stop lever only to switch the power take-off on and off and for emergency
stopping. When disengaging the clutch, you must always turn the twist-grip A to the 0 position
and only then actuate the clutch. This not only protects the clutch, but also other mechanical
components of the basic machine and the attached devices. In addition, dangerous situations can
develop.
Switching the engine off: first release the clutch/safety stop lever
and then switch the engine off.
Important!
Please note that the clutch must always be disengaged in order to switch the power take-off
(switching working devices on and off). The same also applies if you are working with the
hoe and want to drive in reverse. First release the clutch/safety stop lever, turn the twist-
grip to the 0 position and switch off the power take-off! The catch or the safety stop lever
must be replaced immediately in the event of a defect.
The clutch is actuated via the clutch/safety stop lever.
If the clutch/safety stop lever (see fig. 11, left) is not depressed, the engine no longer propels the
machine and the hydraulic drives as well as the power take-off are interrupted.
In order to drive, you must depress the clutch/safety stop lever (fig 11, right).
If the clutch/safety stop lever is released, the machine stops moving. The engine continues to run:
ALWAYS ENGAGE/DISENGAGE THE CLUTCH AT A LOW ENGINE SPEED
Clutch/safety stop lever
Drive OFF position
Engine continues to run
Catch
First depress the catch and then actuate the
clutch/safety stop lever
Clutch/safety stop lever
Drive ON position
When engaging the power take-off, open the
throttle only a little. Engage the power take-off.
If the power take-off does not run, release and
depress the clutch/safety stop lever a few times
until the power take-off runs.
Fig. 11. Clutch/safety stop lever.
Pushbutton
STOP
Fig. 10.
Direction of
travel
Rocker
switch F/R
