Page 13
Version 02-2010
Compakt-Comfort-2
General safety instructions
The protective devices
•
have been installed for the safety of the operator and
•
must not under any circumstances be modified, removed or circumvented by means of
modifications to the
2-wheel tractor.
The safety stop lever serves as an emergency stop switch in dangerous situations where fast
switch-off is required. It swivels automatically into the ‘STOP’ position when released.
13.
Leaving the 2-wheel tractor
•
Switch off the engine and remove the ignition key (if there is one).
•
When leaving the
2-wheel tractor, secure it against rolling away (wheel chock,
apply the stationary wheel lock) and against unauthorised use.
•
Never leave the
2-wheel tractor unattended if the engine is still running.
•
Never leave the operator position at the steering shaft during driving!
•
When parking the tractor, close the petrol stopcock.
14.
Safety of attached devices
•
There is a risk of injury when coupling attached devices. Be especially careful!
•
Attached devices may only be attached when the engine is switched off and the device
drive is disengaged.
•
Secure the
2-wheel tractor and the attached devices against rolling away (handbrake,
wheel chocks).
•
Attach the transport lock and safety device and place them in the protective position.
•
Couple the attached devices according to regulations and fasten them only to the prescribed
fittings.
•
It is not permitted to ride on the attached device of the
2-wheel tractor during work or
transport.
•
Observe permissible axle loads, overall weights and transport dimensions!
•
Check and attach transport equipment (lighting, warning devices, protective devices).
•
Switch the machine off immediately in the case of damage; remove the ignition key of the
2-wheel tractor, if there is one (only with electric starter) and have the damage
repaired.
•
Place protective and safety devices in the protective position again after the repair work is
completed. Only then is operation allowed again.
•
Check the protective devices and working devices for wear.
•
There are crushing and cutting zones on externally powered parts (e.g. hydraulics).
•
It is forbidden to enter or remain in the working, rotating and swivelling area!
•
Before starting work, remove any foreign bodies from the area to be worked.
•
Beware of foreign bodies during operation!
•
Be careful of working tools that run on! Repair work is only permitted at a complete
standstill and with the engine switched off (spark plug cap removed).
•
Be careful when working on a slope! There is a danger of tipping when lifting the
2-
wheel tractor! Drive at a right angle to the slope if possible.
•
When driving outside the working area, disengage the device drive; the
2-wheel
tractor must thereby be raised into the transport position.
•
Never work on the attached device when the engine is running; switch the engine off in
order to carry out such work.
