D R A F T — F O R I N
T E R N A L U S E O N L Y
67
www.kontron.com
User Guide
CP3010-SA
When installed in a CompactPCI peripheral slot, the CP3010-SA operates autonomously, meaning that
it only draws power from the CompactPCI backplane. There is no interfacing with the CompactPCI bus,
clocks or other control signals. In this configuration, the CP3010-SA supports hot plugging. This sim-
ply means that the board can be installed or removed from the system while under power.
Note:
Always ensure that all functions in progress are properly terminated or put into a safe
state prior to hot plugging the CP3010-SA.
Failure to comply with the above may result in improper operation or damage to other sys-
tem components, e.g. operating system failure, data loss, uncontrolled processing, etc.
Note:
In order to use the hot plug function of the CP3010-SA, a hot swap-capable backplane is
required.
8.3.1 Standard Board Insertion
Prior to following the steps below, ensure that the safety requirements are met.
To insert the CP3010-SA in a system proceed as follows:
1.
Ensure that no power is applied to the system before proceeding.
2.
Insert the board into the slot designated until it makes contact with the backplane connec-
tors.
3.
Using the ejector handle, engage the board with the backplane. When the ejector handle is
closed, the board is engaged.
4.
Fasten the front panel retaining screws.
5.
Connect all external interfacing cables to the board as required.
8.3.2 Standard Board Removal
Prior to following the steps below, ensure that the safety requirements are met. When removing a
board from the system, particular attention must be paid to the components which may be hot, such as
heat sink, etc.
To remove the CP3010-SA from a system proceed as follows:
1.
Ensure that no power is applied to the system before proceeding.
2.
Disconnect any interfacing cables that may be connected to the board.
3.
Unscrew the front panel retaining screws.
4.
Unlock the ejector handle.
5.
Disengage the board from the backplane by pressing the handle as required and remove the
board from the system.
