D R A F T — F O R I N
T E R N A L U S E O N L Y
20
www.kontron.com
User Guide
CP3010-SA
1.5 Standards
This product complies with the requirements of the following standards.
Note:
Customers desiring to perform further environmental testing of the CP3010-SA must con-
tact Kontron for assistance prior to performing any such testing.
Boards
without conformal coating
must not be exposed to a change of temperature which
can lead to condensation. Condensation may cause irreversible damage, especially when
the board is powered up again.
Kontron does not accept any responsibility for damage to products resulting from destruc-
tive environmental testing.
In addition, boards ordered with the ruggedized service comply with the following standards as well.
Table 2: Standards
TYPE
ASPECT
STANDARD
CE
Emission
EN 55011, EN 61000-6-4, EN 50155, EN 50121-3-2 (Class B)
Immunity
EN 50155, EN 61000-6-2, EN 50121-3-2
Electrical Safety
EN 60950-1
Mechanical
Mechanical Dimensions
IEEE 1101.10
Environmental
Climatic Humidity
IEC 60068-2-78 (see note below)
WEEE
Directive 2002/96/EC
Waste electrical and electronic equipment
RoHS 2
Directive 2011/65/EU
Restriction of the use of certain hazardous substances in
electrical and electronic equipment
Table 3: Additional Standards for Boards Ordered with Ruggedized Service
TYPE
ASPECT
STANDARD
REMARKS
Environmental
Operating Vibration IEC 60068-2-6
Test parameters:
10-300 [Hz] frequency range
5 [g] acceleration
1 [oct/min] sweep rate
10 cycles/axis
3 directions
Operating Shocks
IEC 60068-2-27
Test parameters:
30 [g] acceleration
12 [ms] shock duration half sine
3 shocks per direction (total: 18)
18 directions
5 [s] recovery time
Operating Bumps
IEC 60068-2-27
Test parameters:
15 [g] acceleration
11 [ms] shock duration half sine
500 shocks per direction
6 directions
1 [s] recovery time
