Könner & Söhnen KS 7HP-1050G, Manual

Page: 31 / 39

30
9. MAINTENANCE
In order to prevent unintentional inclusion of the engine, disconnect the spark
plug of the engine when storaging device, transportation and all the works on
cleaning and maintenance (such work is permitted only with cooled engine).
The use, storage and maintenance of
Könner & Söhnen tillers must be
made according to this manual. For all the damage and malfunctions, which
were caused by mishandling of service, safety and working with the machine
manufacturer is not responsible.
THE MANUFACTURER IS NOT LIABLE FOR:
- Using of lubricants, gasoline and motor oil, which are prohibited by supplier;
- Using the device for other purposes;
- Losses due to further use of faulty tiller parts;
- Technical changes of the device.
MAINTENANCE WORK
All works shown in «maintenance» section should be done regularly. If you can
not perform work, tiller user should contact the service center to complete an
application for technical works execution. In case of losses due to injury, acquired
as a result of outstanding maintenance, the manufacturer is not responsible.
MANUFACTURER IS NOT RESPONSIBLE FOR DAMAGES:
- Damage and losses resulting from the use of non-original spare parts;
- Corrosive damage and other consequences of invalid storage;
- Damage caused by the maintenance works that were carried out by
unauthorized
personnel.
TILLER CLEANING
Thorough cleaning and care of the device extends its life and protects it from
damage. After each use, clean the tiller blades of the land, dust and grass straw.
Keep under control the state of the product – damaged parts, landing threaded
elements.
It is forbidden to send jets of water on the seals, engine components and bearing
seats. Otherwise the tiller may need an expensive repair.
CHAIN TRANSMISSION REGULATION
From time to time, after extended tiller use, regulation of chain transmission is
necessary. To do this, follow these steps:
1. Remove the chain transmission, previously removing its screw.
2. Grip the handle grip. Check the distance between the upper point of the belt
and upper-point of roller – it should be 60-65 mm (2.4-2.5 inches).