Könner & Söhnen KS 7HP-1050G, Manual

Page: 28 / 39

27
8. OPERATION INSTRUCTION
COMMISSIONING
During the commissioning:
1. Fill the crankcase with engine oil SAE 10W-30
or SAE 10W-40.
2. Fill the transmission case with SAE 75W-90,
SAE 80W-90 or SAE 85W-90 grade oil to the level
specified for a given model. Be sure to check the
oil level with an oil dipstick, as the device may
contain residual oil after a production check. Do
not exceed the recommended amount of oil!
3. Fill the fuel tank with gasoline.
4. Unscrew the air filter cover (Fig. 17) and fill 50-100 ml of engine oil into the
air filter separator. Package contents may vary. For an engine with a paper filter,
there is no need to fill the separator with engine oil.
USEFUL TIPS
1. To determine the tilling depth, use the coulter at different heights. With the
coulter driven deeper into the soil, the cutters also go deep into the soil and the
movement of the device forward slows down considerably.
2. The tiller speed is determined by adjusting the engine speed. The cutters go
deep into the soil with the device in the fixed position.
3. To speed up the tiller movement, adjust the coulter higher to lift the cutters.
4. Immediately release the clutch lever when the tiller is blocked by foreign
objects. Stop the engine, remove obstacles and check the tiller for deformation
and damage. Replace damaged parts as necessary.
filter cap
filter element
fill 50-100 ml of oil
Fig. 17
Fig. 16
Fuel tank
Oil filler cap/
oil dipstick
The tiller is supplied without oil and fuel.
Before first start-up, be sure to fill in the oil and refuel the device!
Use a funnel to refuel.
! !
ATTENTION - DANGEROUS!