Könner & Söhnen KS 7HP-1050G, Manual

Page: 29 / 39

28
FUEL AND ENGINE OIL
The tiller needs normal unleaded fuel with 92 octane for proper work.
Gasoline should be fresh. Use a funnel (not supplied) for best device filling.
The tiller also can not run without oil, so fill it before the first launch. Set the device
on a flat horizontal surface, open the tank with oil and pour oil to the minimum mark
and add fresh oil to the mark between MIN and MAX. Use the probe to check the oil
level. Oil level must be constantly monitored. Do not let excess of oil and its lack.
Information on used motor oil can be found in the technical characteristics of the tiller.
STARTING THE ENGINE
Before starting the engine, make sure the switch is in position I (on) (see Fig. 20).
Turn the rotary engine speed dial to MAX (see Fig. 19). Damper motor switch to
position CHOKE (see Fig. 18). Grasp the starter handle (see Fig. 21) and slowly
pull it to the emergence of resistance, then sharp fast motion pull starter all the
way. Repeat the operation until the engine starts. After starting the engine let the
rope to entangle on trigger without throwing the starter handle. Put the flaps in
position RUN.
Fig. 18
Air damper
Fuel valve
Fig. 19
Throttle governor
MAX
MIN
Fig. 20
Engine switch
OFF
ON
The engine switch is located on
the control panel handle.
Open Close
Open
Close