Könner & Söhnen KS 7HP-1050G, Manual, Page: 11 / 39

10
OPERATION OF THE DEVICE AT THE GOOD LOCATION
1. Keep track of the correct location of the appliance on the slopes. The angle
of inclination of 10% corresponds to 10 cm, a rise of 100 cm to the horizontal
plane. Do not apply soil plowing on steeper slopes, in order not to lose control
of the device.
2. When working on slopes or hilly terrain, reinstall all mills.
3. The person working with the tiller is prohibited from standing below the
device in order to avoid getting into the working tiller in case of loss of control
over it.
4. It is prohibited to operate the device across the slope. Only move forward, do
not pull the tiller back and forth.
5. Be careful when changing the direction of the tiller.
6. Reduce speed on rocky soil.
7. Work with the tiller should occur only in the pace of the step, as there is a
risk of stumbling, slipping, etc. when moving fast.
8. To adjust the depth of the device, change the force of pressing on the handle,
pressing the coulter in the ground more or less.
9. Do not turn engine, do not change its main position!
STORAGE AND USE OF GASOLINE
Petrol is extremely toxic and combustible, so observe the following rules for its
storage and use:
1. Only store fuel in hermetically sealed containers specially designed for this
purpose. Hold the canister with gasoline in the cool dark place as far away from
sparks and open flames.
2. During operation of the engine, the tiller allocates exhaust gases that can
cause poisoning. Do not use the device in closed, badly ventilated areas.
3. Fill the tiller in the open air before starting the engine. Do not squeeze the gas
tank cover and do not fill the fuel if the tiller is still hot after work.
4. Leave the place to expand the fuel after refueling. Pour fuel to the edge of the
filling pipe (about 4 cm from the top of the tank). Do not fill the tank completely.
5. If there is too much gasoline, thoroughly wipe excess from the surface if it is
filled with fuel. In no case do not start the engine until the surface is cleaned up
and until steam of gasoline evaporates.
6. Always close the gasoline tank cover tight.
7. To empty the fuel tank, start the tiller engine out of the room until complete
fuel production.
8. The tiller should only be transported empty. A fuel tank and a closed fuel tap.
9. Wait until the device cools down before putting it on storage.
10. For safety reasons, do not leave the fuel in a fuel tank. Gasoline vapors can
come in contact with sparks or open flame, which may lead to vaporization.
11. Regularly check the device for damage and imperfection of the fuel line, tank
and fuel tank plugs, as well as damage to the muffler and protective plates. In
time, replace the parts if necessary.
MAINTENANCE AND REPAIR
When using a tiller on slopes, lifting must not exceed 10% (5.7°). Operation of
the device is possible only in daylight or good artificial lighting to avoid injury
and damage.
Use only original spare parts, replace worn or damaged parts on time, tighten all
bolts, screws and nuts all the way.