prints. To toggle the indicator, continue to hold down the Clear/Shift button and release
and press the Paper Select button a second time.
page number, date and time from print to print. In order
do so, the scanners use temporary on-board storage that, in between prints, is
dynamic
verlays the scanner must have a SCSI connection to a PC that has the Overlay Monitor
by pressing the Clear/Shift button and the Paper Select button for one second.
hen in dynamic mode the LED will display a 2c setting. When using dynamic
Using
To beg
are exp
1)
ctive/disabled.
2)
reate an overlay in the Overlay Editor and then enable the Overlay Monitor.
3)
Use the Configuration Editor to select the scanner, select the overlay bitmap, select the
overlay location and to set the overlay mode as dynamic or static.
4)
Make a print.
Once these steps have been followed, the selected scanner has stored the static overlay
internally. It can now be used as is until cleared or changed by the Overlay Manager. The PC
no longer needs to be connected or used to utilize that overlay.
If you desire to have a dynamically changing overlay with date, time or page number then the
scanner must stay connected to a PC that has the Overlay Monitor active and running. Each of
the Overlay Manager modules is explained in detail below with further instructions for using
dynamic overlays.
d as a small MS 7000 scanner icon with
Monitor automatically start each time Windows is
Dynamic:
In Dynamic mode, the MS 6000 and MS 7000 can annotate an overlay with
changing information such as
to
repeatedly populated by the Overlay Manager software. In order to use
o
active. The only way to active dynamic mode is to enable it in the Overlay
Configuration Editor and make sure the Overlay Monitor is active. When all these
criteria are met, the scanner is automatically placed in dynamic mode. This can be
verified
W
overlays the overlay cannot be disabled via the front panel but instead must be done
through the software.
the Overlay Manager Software
in using overlays on output you will need to follow these steps -- the details of which
lained fully in the following subsections.
Launch the Overlay Monitor (if not done so during the install) – once launched it may
still be ina
C
The Overlay Monitor
The first step to creating and using overlays is to ensure that the Overlay Monitor is active and
running in the Status Area of the Windows Task Bar. The Task Bar is typically located along
the bottom edge of your monitor and the icon itself will be to the far right-hand side of the
ask Bar (next to the clock display). It can be identifie
T
a colored screen. If you wish to have the
launch then you will need to indicate this in the Overlay Configuration Editor (
see below
).
Summary of Contents for MS 2000
Page 52: ......
