Konica Minolta DRYPRO 873, Operation Manual, Page: 66 / 124

66
Maintenance Mode
4
Use the [Test print] and [Calibration] buttons to move the cursor to an
item, and press the [Service/Enter] button to select and set that item.
Press a tray button to move the cursor to the [Tray Use] icon for the se-
lected tray�
The selected setting changes in the following order:
[Tray 1: Tray Use] → [Tray 1: Film Size] → [Tray 1: Film Type] →
[Tray 2: Tray Use] → [Tray 2: Film Size] → [Tray 2: Film Type] →
[Tray 3: Tray Use] → [Tray 3: Film Size] → [Tray 3: Film Type] →
[Sorter Use] → [OK] → [Tray 1: Tray Use] • • •
• [Tray Use]
Press the [Service/Enter] button to enable or disable the selected tray.
[ON] → [OFF] → [ON] • • •
• [Film Size]
Press the [Service/Enter] button to change the film size of the selected tray.
[14x17] → [14x14] → [11x14] → [10x12] → [8x10] → [14x17] → • • •
• [Film Type]
Press the [Service/Enter] button to change the film type of the selected tray.
[B] → [C] → [M] → • • •
• [Sorter Use]
Press the [Service/Enter] button to enable or disable the sorter.
[ON] → [OFF] → [ON] → • • •
5
Move the cursor to [OK] and press the [Service/Enter] button to save the
settings�
(If the following message appears, the settings were not saved properly. In this case,
shut down the main unit, restart it, and then configure the settings again.)
6
When the [Reset/Cancel] button is pressed after changing the settings, a
save confirmation message appears.