Konica Minolta Drypro 832, Manual

Page: 54 / 84

54
4�1 Need Help?
If there are signs of failure, check in accordance with the following table. See also the appropriate
page. If there is no improvement in symptoms, contact Konica Minolta technical representatives.
Problem Items to be checked Refer to
Power is not turned
on Did you press the operation switch until a
beep sounds (approximately one second)?
Did you press the operation switch twice?
Is the power supply circuit breaker turned on?
If you shut down by holding down the opera-
tion switch for 10 seconds, did you turn off the
power supply circuit breaker once after that,
and then turn it on?
Is the power supply of the outlet normal? 3.1.1 How to Start (page 34)
Not printed Is an error message shown in the message
display window?
Is a film size consistent in a study? 4.2 Error Display and Solutions
(page 55)
Film jam
occurred Identify the section where a film jam occurred. 4.4 How to Clear a Film Jam (page 57)
Cannot shut down Did you press the operation switch until a
beep sounds (approximately one second)?
Did you hold down the operation switch for 10
seconds?
3.1.2 How to Shut Down (page 36)
Tray cannot open Is the message “Film Empty” shown in the
message display window?
Is the machine in the course of printing?
Is the another user logged in for maintenance? 3.3 Loading Films (page 38)
An error message
is displayed Check the error message. 4.2 Error Display and Solutions
(page 55)
The diagnostic im-
age is not output Is [E9211] displayed in the message display
window? 4.2 Error Display and Solutions
(page 55)
Cannot communi-
cate with Printlink5-
IN/console Is “PC not connected” displayed in the mes-
sage display window?
Is a communication cable connected to the
Ethernet port properly? 2.2.4 Interior (page 30)