Konica Minolta Drypro 832, Manual

Page: 36 / 84

36
Starting and Shutting Down
3�1�2 How to Shut Down
To shut down DRYPRO 832, perform the following steps.
Check the following points before performing a shutdown opera-
tion�
• The message “Printing” is not shown in the message display window.
If the machine is not shut down after the expiration of three min-
utes or more following a shutdown operation, press and hold the
operation switch again for 10 seconds or longer� The machine will
be shut down� Then, turn OFF the power supply circuit breaker,
and turn it ON again�
After the shutdown operation completes, the deodorant fan contin-
ues to operate for approximately 1 hour�
When performing the shutdown operation, do not switch the power
supply circuit breaker OFF immediately� (To turn the power supply
circuit breaker off, wait approximately 1 hour after completing the
shutdown operation before switching the breaker off.)
1
Press the operation switch until a beep sounds (about one second)�
The message “Now shutting down Please wait a while” appears in the message
display window and the status LED goes out.
The machine will be shut down in about 10 seconds.
• Leave the power supply circuit breaker ON during normal use.