Konica Minolta 7915, Instruction Manual

Page: 203 / 284

Administrator Mode Operations 9
Konica 7915/7920 9-27
To set the “PRT Area (Top Margin)” parameter
This parameter can be used to adjust the paper feed position in the sec-
ondary scanning direction when making single-sided copies. In addition,
this can be adjusted for each paper type. This parameter can be set be-
tween –2.0 mm and +2.0 mm, in increments of 0.2 mm.
Note)
✔ This adjustment affects paper loaded into the standard paper drawer,
the manual bypass tray, the optional 500-sheet paper feed unit, and
the optional large capacity tray.
✔
The multipurpose paper drawer (1st drawer) is the tray that is checked
and adjusted.
✔ The top margin of the print area is adjusted during manufacturing of
the copier. Normally, the top margin will not need to be adjusted.
1
In the Expert User’s Mode screen,
touch [2/2], and then touch [PRT Area
(Top Margin)].
The Top Margin screen appears.
2
Load paper (A3L) into the 1st drawer,
and then press the [Start] key to print
out the test pattern.
The screen at the right is displayed if
the paper type dial on the 1st drawer
is set for normal paper.