Komatsu H75051, Operation & Maintenance Manual

Page: 380 / 440

A: Front, B: Rear
1.
Place a container under drain plug (P) to catch the drained oil.
2.
Remove front and rear plugs (1), then remove drain plug (P) to drain the oil.
REMARK
Remove the mud and dirt from around plug (1), then remove the plug.
3.
After draining the oil, clean and install drain plug (P).
4.
Add the refill capacity of oil through plug hole (1).
REMARK
Be careful that the amount of the lubricating oil for the axle with Limited Slip Differential may be different.
Always use the specified lubricating oil.
5.
Wipe off oil of dipstick (G) installed to plug (1) by using a piece of cloth.
6.
Set dipstick (G) as shown in the figure.
(2): Axle
(3): Spot facing surface
7.
Check the oil level.
The oil level is appropriate if it is between 2 grooves (H)
and (L) of the dipstick.
8.
If the oil does not reach the lower groove (L), supply the
axle oil from plug hole (1).
9.
If the oil level exceeds the upper groove (H), drain the ex-
cessive oil through the drain plug (P), and then check the
oil level again.
10. If the oil level is appropriate, install plug (1).
Tightening torque: 93 to 123 Nm {9.5 to 12.5 kgm}
REMARK
When the given work requires to use the brake more fre-
quently than usual, replace the axle oil earlier than the
usual timing.
MAINTENANCE PROCEDURE MAINTENANCE
4-70