Fig.#2
2
Remove old gasket from the floor and
closet flange with a putty knife.
Remove old T-bolts and discard them.
if a new toilet is not installed
immediately, temporarily stuff a rag in
the closet flange.
NOTICE:
T
Closet Flange
B. Roughing-In
DANGER: Risk of electric shock.
NOTE:
WARNING: Risk of electric shock.
Disconnect power
before servicing.
This product is designed to work with either wall or
floor mounted electrical and water supplies. Both types are
shown in the rough-in art.
Connect only to
circuits protected by Ground-Fault Circuit-Interrupters
(GFCI s) or Earth-Leakage Circuit-Breakers (ELCB s).
When the electrical supply is mounted on the wall, a GFCI or
ELCB protected and water proof receptacle is required.
Follow the dimensional information exactly when installing a
hardwire electrical supply.
'
'
B.
(GFCI)
(ELCB)
(GFCI)
(ELCB)
A. To Remove Existing Toilet
Turn off the water supply. Flush the toilet, and use a sponge
to remove the remaining water from the tank and bowl.
Disconnect the supply shut-off valve (if present), and remove
the old tank and bowl.
A.
INSTALLATION
C. Install the T-Bolts
Install two new 8mm (5/16") diameter
T-bolts into the floor flange.
Do not use white cement or high lime
content cements to install this toilet.
The expansion of cement due to a rise
in temperature may make the toilet
crack or cause damage. Kohler is not
responsible for any damage caused by
installation with the use of cement.
C.
T
8mm
T
(5/16")
Fig.#3
3
T-Bolts
T
Floor Flange
1061926-T01-A
