I. Install the Collar
Place the wiring harness plug, level switch wire, and refill
tube on the floor so they extend out the rear access opening.
Tape them to the floor so they will not be pinched or damaged.
Install the collar onto the tank.
Clip the spray shield into place over the fill valve.
I.
J. Install the Vitreous Shell
WARNING: Risk of personal
injury.
CAUTION: Risk of product
damage.
The vitreous shell
weighs 80 lbs. (36 kg). Use
proper lifting technique when
handling the vitreous shell.
Do not set the shell
down hard. Gently lift and move
the shell if it is not placed
correctly. If handled harshly, the
shell may chip or break.
Carefully pick up the vitreous shell and
place it over the tank.
Make sure the trapway seats fully in
the outlet gasket. If the vitreous shell
does not sit evenly on the floor, the
trapway is not properly seated.
Make all adjustments gently until the
trapway is properly seated.
J.
80
36
Fig.#8
8
Wiring Harness Plug
Tape
Refill Tube
Level Switch Wire
Centerline
Electrical Plug
Collar
Spray Shield
Tank
Vitreous
Collar
Tank
Fig.#9
9
-6-
1061926-T01-A
