27
1306246-W2-D
Post Installation Procedure
Turn on the electrical
supply.
Turn the temperature to
full cold.
Start the shower to test for water
flow and run for at least 1 minute. If a
shower drain pump is fitted, it should
also start. If there is no water after 5
seconds, make sure that appliance
has been primed.
The shower will beep once when start/stop
button is pressed (3 times for BEAB mode).
The white start/stop and blue status light will
pulse and shower will beep again. After a few
seconds the shower will beep again and the
lights will go solid. This will confirm flow and
cold temperature.
5 secs
Turn on the power to appliance,
check
Start/Stop
for white light.
x1
Push
Start/Stop
to turn off
appliance. Pulsing start/stop light
and "beep" indicates that appliance
is shutting down.
Appliance will purge water from heater tank
for a few seconds.
Important! DO NOT
isolate power until water
has stopped.
1
2
3
4
x1
6
5
7
BEAB X 3
Summary of Contents for Mira Advance 8.7
Page 38: ...38 1306246 W2 D Notes ...
Page 39: ...39 1306246 W2 D Notes ...
