28
1306246-W2-D
Turn the temperature control to the full
hot position and continue to run the
shower for at least 1 minute.
This completes the installation of the Mira Advance shower. Please advise the
user how to operate their new shower and leave them with user instruction
guide.
Post Installation Procedure (Continued)
Turn on the electrical
supply.
Turn the temperature
control to number 8.
Turn on the power to appliance,
check
Start/Stop
for white light.
Note!
The shower will beep 3
times if set to BEAB mode
8
9
10
Start the shower to test for water flow.
The shower will beep once (3 times
when set in BEAB mode) and the white
start/stop light and orange status light
(green in BEAB Mode) will pulse. Wait
until the lights go solid and the shower
will beep again.
Push
Start/Stop
to turn off appliance.
Pulsing start/stop light and "beep"
indicates that appliance is shutting down.
Appliance will purge water from heater
tank for a few seconds.
Important! DO NOT
isolate power until
water has stopped.
11
12
13
14
Summary of Contents for Mira Advance 8.7
Page 38: ...38 1306246 W2 D Notes ...
Page 39: ...39 1306246 W2 D Notes ...
