Koden CVS-126, Operation Manual

Page: 64 / 73

Chapter 5 Installation CVS-126
5-10 0093132702-08
Connection with Speed Sensor or Water Temperature Sensor (Option)
When installing the optional speed sensor or water temperature sensor, connect to the [TD] connector
together with the transducer via the transducer cable (Type: CW-840-0.3M). For wiring, see the figure
below.
After soldering, implement the waterproof and insulation treatment on the connected part with the
self-melting tape.
Structure of Transducer Cable
Caution: Wind the insulation tape around the un-used lead wire for core-wires not to contact
each other.
Connection Table of Transducer
Transducer Cable Transducer
No. of 2 core shield Color of 2 core shield TD-500T-2B
TD-500T-3B
3 Orange Red
4 Shield Shield
5 White White
Connection Table of Speed Sensor and Water Temperature Sensor
Transducer Cable Water Temperature Sensor / Speed Sensor
No. of lead
wire
Color of lead
wire
T-81 ST-80
ST-80-1
ST-90
ST-90-1
ST-100
ST-100-1
1 Blue — Green Green Green
2 Violet — Red Red Red
6 Green Gray White White White
7 Red Gray Brown Brown Brown
8 Black — Shield Shield Shield
Caution: No.8, SPD.GND (Black), only use for speed sensor.
Do not connect with other grounding wire.
2 core shield wire
TD1 (Orange)
TD2 (White)
Shield
SPD.PULSE (Blue)
SPD.VCC (Violet)
SPD.GND (Black)
TEMP.VCC (Green)
TEMP.SIG (Red)
lead wire
To the speed sensor
To the water temperature sensor
To transducer