Kodak AFi 10, User Manual

Page: 56 / 230

Setting tethered power to battery
Power sources vary, and if the power to the imaging module is insufficient , then you must opt to power
the camera system from the battery in the handgrip. Perform this task when you connect your system to
your computer and the imaging module does not turn on.
This task is performed on the Leaf AF i imaging module, in Setup view.
1. Remove the FireWire cable.
2. Turn your camera system off and on again.
3. On the imaging module, tap Setup .
4. Tap Tethered Imaging Power .
5. Tap Camera Battery to power the imaging module using power from the battery in the handgrip.
6. Turn your camera system off.
7. Connect your camera system to your computer using a FireWire cable, and then turn on the camera
system.
Both the camera and the imaging module are now powered using the battery in the handgrip. As you
shoot, your shots are sent to your computer.
Important: The Tethered Imaging Power is set to Battery until you change it. If you use your Leaf AF i
camera system on a different computer, reset the Tethered Imaging Power to FireWire .
56
Powering the camera system