1-10
A-61316 April 2010
To turn the power off
1. Press the power switch of the scanner to the O (Off) position.
2. Press the power switch of the printer to the O (Off) position.
NOTE: The printer and scanner can be turned on and off at the
same time by employing a cord that is equipped with an on/
off switch. Make sure all cords used comply with the
specified ratings of the unit.
Auto Power Save/
Projection lamp
functions
The scanner enters the Auto Power Save mode if it is left to stand idle
for a predetermined period of time. When the scanner enters the Auto
Power Save mode, power to the scanner projection lamp and the
printer heater is automatically shut down to save power consumption.
The User Mode function allows you to set the time it takes the unit to
enter the Auto Power Save mode. The setting options are as follows:
• Auto Power Save (15 min.)
• Auto Power Save (30 min.)
• Auto Power Save (60 min.)
NOTE: The Auto Power Save mode can be disabled. Ask your Kodak
Representative if you want to disable this function.
Segments of the Multi-Print Display light up and go out sequentially in
the clockwise direction when the unit is in the Auto Power Save mode.
To leave the Auto Power Save mode, press any key on the control
panel. The scanner projection lamp will light steadily and the printer is
set into the warm-up condition.
NOTE:
For the USA and Canada only:
You must have the Energy Miser
Kit installed to use this function.
