KODAK
1200i WIDE-FORMAT PRINTING SYSTEM
Technical Training Guide
12
Step 8:
Ink Line Filling
- After installing the 6 ink bottles and waiting 5 minutes, select
‘Access Cartridges’.
- Install the
Cartridge with Tube Assembly
into the first stall
position; attach tube needle to right side plate septum fitting
(under access cover).
NOTE:
the cartridge with tube
assembly (+plug bar) ships in a
small box within the printer
head box.
- Activate tube fill by selecting and holding
Utility Menu -
Prime Menu – Service Station Menu – ‘Pump On’
.
- The fill process takes approximately 4-16 seconds per
color. When ink reaches the cartridge tube release the
‘Pump On’ selection. Repeat procedure for remaining colors.
NOTE:
To flush the ink system refer to
Technical Bulletin 2
. Only use the
authorized Flush Kit (part number 221984-00) to evacuate
ink lines and clean the system of ink prior to printer transport.
Step 9:
Cartridge Installation
Open cartridge door by pulling up on door at a 45 degree angle.
Remove tape from cartridge. Slide cartridge into cartridge stall and
close cartridge door until it locks.
Note:
door must be closed to properly bias cartridge position.
