42
7. Operation
7.4 Changing the front / rear grinding wheels
Open the protective doors.
Set the grinding discs to a comfortable position
(approx. 34° – see Chapter 7.5).
ATTENTION
Turn the “Setting Mode” key switch
(3-7/5) to position “1”.
Use SW6 Allen wrench to loosen and remove the
screw at the center of the grinding wheel (7-25/1)
by turning it counter-clockwise.
Remove the front or rear grinding wheel and also
the connection flange (7-26/1) if necessary and
mount the new grinding wheel in the reverse
order.
If the grinding wheel is half-worn, mount the in-
termediate flange (7-26/1) with an M8x40 screw.
NOTICE
Two intermediate flanges with corresponding
screws are included in the accessories.
Figure 7-24
Adjust the grinding angle
Figure 7-25
Change the grinding wheels
1
Figure 7-26
Intermediate flange
1
