26
Operation
P 2.1S/P 4.1S user manual V6870, version 3.1
Via Local Area Network (LAN)
A device connected to a LAN is recognized by the software and automatically
receives an IP address because it is set to Dynamic Host Configuration Protocol
(DHCP) at the factory.
Prerequisite:
Device has been connected to LAN.
Status display is active.
Result:
When setting is finished, the status display appears.
Via RS-232 Port
Prerequisite:
Interface RS-232 is connected.
Status display is active.
Result:
When setting is finished, the status display appears.
Control commands
The control commands listed below are considered for the communication with
RS-232 and LAN. When entering a parameter, you must place a colon or space
between command and parameter value, e. g. PMIN10:100.
Consider the following specifications for data transfer with RS-232 interface:
9600 baud
8 bit
1 stop-bit
no parity check
Process
Figure
1. Press both arrow keys simultane-
ously until the correct display
appears.
2. Let go of the arrow keys.
3. Using the arrow keys, scroll until
LAN.
Fig. 18
Display control
Process
Figure
1. Press both arrow keys simultane-
ously until the correct display
appears.
2. Let go of the arrow keys.
3. Using the arrow keys, scroll until
RS-232 is displayed.
Fig. 19
Display control
