Unpacking and Setup
13
P 2.1S/P 4.1S user manual V6870, version 3.1
Power supply
The device is intended for use with AC power networks of 100 – 240 V.
Power cable
Only the supplied power cable is to be used to connect the device to the mains
supply. Replace defective power cables only with accessories from KANUER.
Only use power cables with a permission for use from your country.
Power plug
Make sure that the power plug on rear of the device is always accessible, so that
the device can be disconnected from the power supply.
Unpacking
Store all packing material. Retain included packing list carefully for repeat
orders.
Bruising danger
Damage to the device by carrying or lifting it on protruding housing parts. The
device may fall and thus cause injuries.
Lift the device on the side of the housing only.
Process:
1. Setup the delivery so you are able to read the label. Using the utility knife,
cut the adhesive tape. Open the delivery.
2. Remove the foam insert. Take out the accessories kit and the manual.
Weight
1.5 kg
Dimensions
105 × 100 × 185 mm (Width × Height × Depth)
Power supply
24 V DC
Air humidity
< 90 %
Temperature
4 – 40 °C (39.2 – 104 °F)
Space requirements
Side clearance to other devices:
If there is a device on one side, minimum
clearance of 5 cm.
If there are devices on both sides, minimum
clearance of 10 cm
At least 30 cm gap to the fan on the rear of the
device.
