klover AURA 120, Installation, Use, Maintenance And Helpful Tips

Page: 35 / 68

30
AURA 80, CLASS 90, AURA 120, REA 100 PELLET-BURNING STOVE EN - Rev. 1.6
The table below shows the settings and their meanings:
Menu Meaning Values that can be set *
CARD BEEP Enables/disables the beep sound made by the power card ON – OFF
DISPLAY ILLUMINATION Regulates the duration of the display illumination 2 / 10 secs
DISPLAY ON Regulates the duration of the display activation 15 / 60 secs – ON
DISPLAY BRIGHTNESS Enables/disables display illumination ON – OFF
DISPLAY CONTRAST Regulates the display contrast 15 / 60 #
KEY BEEP
Enables/disables the beep sound made each time a key on the remote control is
pressed
ON – OFF
* The values set affect the life of the batteries fitted in the remote control.
Menu 06 – Initial load
Enables pellet pre-loading for 90” when the appliance is switched off and cooled down. Start the function with key 1
(Increase) and stop with key 3 (On/Off). This may be useful if the appliance is switched on after the tank has been
completely emptied, or when it is filled for the first time. Warning: once the operation has been completed, before
switching on the appliance you should remove any accumulation of pellets deposited inside the ash drawer.
Menu 07 – Fireplace status
Allows for viewing the current status of the appliance, by showing the operating conditions of the various devices
connected to it. Several pages are displayed in succession. The data is reserved for Technical assistance Centre.
The table below shows the various devices and their meanings:
Display Meaning
L04-270218 (example) Firmware code loaded in the control unit.
ARIA 1.0 (example) Firmware code loaded in the remote control.
F.GS.T Indicates the temperature read by the sensor inside the combustion chamber.
R.TMP. Indicates the room temperature as measured by the sensor inside the remote control.
R.TMP 1
If a temperature sensor is connected, this indicates the temperature in ducted room 1 measured by the same.
If a room thermostat is connected, this indicates the status of the same
(OFF = R.T. contact OPEN = Thermostat not in demand)
(ON = R.T. contact CLOSED = Thermostat in demand)
R.TMP 2
If a temperature sensor is connected, this indicates the temperature in ducted room 2 measured by the same.
If a room thermostat is connected, this indicates the status of the same
(OFF = R.T. contact OPEN = Thermostat not in demand)
(ON = R.T. contact CLOSED = Thermostat in demand)
EX.RPM Indicates the speed of the flue extractor fan.
LOAD Indicates the pellet loading interval.
R.T. STATUS
Indicates the status of the main room thermostat.
(OFF = R.T. contact OPEN = Thermostat not in demand)
(ON = R.T. contact CLOSED = Thermostat in demand)
SPE.AIR Indicates the speed of the front air fan.
SPE.DUC1 Indicates the speed of ducted air fan 1.
SPE.DUC2 Indicates the speed of ducted air fan 2.
TIMER 1 Indicates the end (minutes) of the current operating phase.
TIMER 2 Indicates the end (seconds) of the current operating phase.
DEL.ALARM Indicates in an alarm state, the time (seconds) before the alarm condition is shown on the display.
T.CARD. Indicates the temperature read by the sensor inside the control unit.