Klever ZTT-3,2 Strige, Operation Manual

Page: 30 / 64

30
8.2.4 List of works to be performed upon removal from storage
When removing from storage, the following is required:
• assess the technical condition of the machine, eliminating the identified shortcomings;
• unlock the machine;
• perform works on preparing the machine for operation in accordance with Section 5 of this
Operating Manual.
8.3 Mower lubrication
During operation, lubricate the mower in accordance with Table 8.1, 8.2 and Figure 8.1.
It is necessary to:
- apply the main grease Litol-24 GOST 21150-87 or the duplicating Lubricant No. 158M
TU 38.301-40-25-94;
- before greasing, remove dirt from the lubricator;
- distribute the lubricant evenly, switch on the cutting device of the mower and scroll at
idle speed for 2-10 minutes.
Table 8.1
Lubrication components
Number of
lubrication points /
volume, kg
Type of lubrication
Periodicity of
lubrication, h
Sliding bearing of the
hitch
1/0,01
Litol-24 (ML4 / 12-3)
GOST 21150-75 or
Lubricant No. 158 TU
38.301-40-25-94
Once a season or
during repair
Sliding bearing of
small beam
1/0,07
10
Hydrosystem Oils used in the hydraulic
system of the tractor constantly
Conical reduction
gear of the cutting
device
1/0,75
Transmission oil TAD-17I
GOST 23652-79 or any
class SAE-90ER 240 or once a season
Cutting device crank
1/3,0*
SAE-80W90 100 or once a season
Sliding gear reducer
bearing
1/0,14
Litol-24 (ML4 / 12-3)
GOST 21150-75 or
Lubricant No. 158 TU
38.301-40-25-94
10
Drive shaft
6/0,1
Litol-24 (ML4 / 12-3)
GOST 21150-75 or
Lubricant No. 158 TU
38.301-40-25-94 According to figure 8.1
and table 8.2
Preservation
Preservative oil NG-203B At placement to
storage