![Klever ZTT-3,2 Strige Operation Manual Download Page 13](http://html1.mh-extra.com/html/klever/ztt-3-2-strige/ztt-3-2-strige_operation-manual_1977615013.webp)
13
Warning!
The following should be considered at replacement of knives:
• knives should be changed in pairs;
• knives should be installed taking into account the direction of rotation;
• only original knives should be installed;
• tightening torque of the knife fixing nut M = 95 N · m.
Knives should be replaced according to figures 3.6, 3.7
.
1 - Rotor; 2 - Nut; 3 - Knife; 4 - Bolt
Figure 3.6 - Mounting of mowing knife to the rotor
Figure 3.7 - ZTT-2,8 mowing knife replacement scheme
Knife fastening bolt is subject to replacement in the following cases (ref. to Figure
3.6):
1)
Bolt is deformed;
2)
Bolt is worn enough on one side;
3)
Diameter of the blade seat is less than 15 mm.
Knife fixing nut is subjected to replacement in the following cases (ref. to Figure
3.9):
1)
Nut was tightened more than 5 times;
2)
Height of the nut is less than half the width of the hexagon.
Summary of Contents for ZTT-3,2 Strige
