8
MAINTENANCE
BATTERY REPLACEMENT
When the Power-On indicator
4
blinks, the battery must be replaced.
1. Open the battery compartment door
10
by unscrewing the
locking screw.
2. Remove exhausted 9V battery and dispose of appropriately.
3. Replace the 9V battery, close the battery door, and re-fasten the
locking screw.
CLEANING
Be sure unit is turned off and wipe with a clean, dry lint-free cloth.
Do not use abrasive cleaners or solvents.
Take care to keep the
sensor lens clean at all times. If required, loose debris may be
removed from lens using clean compressed air. Lens may also be
cleaned using a soft cloth or cotton swab with water or rubbing
alcohol only. Lens must be allowed to completely dry prior to use.
STORAGE
The transmitter
1
may be docked in the transmitter receptacle
11
in the receiver
2
for convenient storage. Remove the batteries when
the tester will not be used for a prolonged period of time. Do not
expose to high temperatures or humidity. After a period of storage
in extreme conditions exceeding the limits mentioned in the General
Specifications section, allow the tester to return to normal operating
conditions before using.
WARRANTY
www.kleintools.com/warranty
DISPOSAL / RECYCLE
Do not place equipment and its accessories in the trash.
Items must be properly disposed of in accordance with local
regulations. Please see
www.epa.gov
or
www.erecycle.org
for additional information.
CUSTOMER SERVICE
KLEIN TOOLS, INC.
450 Bond Street Lincolnshire, IL 60069 1-877-775-5346
[email protected] www.kleintools.com
ENGLISH
MANUAL DE INSTRUCCIONES
ESPAÑOL
Detector digital
de cortacircuitos
• INDICACIONES
VISUALES Y AUDIBLES
QUE IDENTIFICAN
CLARAMENTE EL
CORTACIRCUITOS
CORRECTO
• FUNCIONA EN
90 V-120 V CA
• DETERMINA
CONDICIONES DE
CABLEADO EN
TOMACORRIENTES
• PRUEBA DISPOSITIVOS
GFCI
2 m IP40
ET310
5000573
