Instructions for use, installation and connection
18
Removing wire and telescopic guide
grids
Telescopic side racks or wire racks may be
removed to facilitate the cleaning of the oven.
Side racks are removed by swinging the bottom
side inwards and unhooking them.
Clean the side racks and telescopic guides only
with conventional detergents.
Telescopic racks must not be washed in a
dishwasher.
Note
! Never lubricate the telescopic racks!
To reinsert, repeat the procedure backwards:
slide them into the holes and swing downwards.
Oven ceiling
(differ according to different models)
To facilitate the cleaning of the ceiling some
ovens are equipped with the foldable infrared
heater.
•
Before lowering the infrared heater disconnect
the appliance from the mains by unlocking the
fuse or switching off the main switch.
•
The heater must be cooled down, otherwise
you might get burned!
•
Never use the heater in the lowered position!
Before cleaning remove all pans, grids and
guides, and using suitable tools (knife or a
screwdriver) loosen the cross bar from its side
supports (see fig.). Use your other hand to hold
the heater and fold it downwards.
After cleaning simply push the heater back and
the cross bar will click into position.
Accessories
Accessories, like the biscuit tray, oven tray, etc.
are cleaned with hot water and the usual
detergent.
Special enamel
The oven, interior door lining, baking tray and
grease interception pan are coated with special
enamel, with smooth and resistant surface.
This special coating facilitates cleaning at room
temperature.
Grease filter
Clean the grease filter after each use with a soft
brush in hot water with some detergent, or wash it
in the dishwasher.
Removing oven door with a single
axe hinge
Open the door completely and turn the removable
locks backwards (see fig). Then close the door
slowly and let the locks fit to the notches. At an
angle of about 15
°
lift the door slightly up and pull
the door from the hinge supports (fig. 2).
For reinserting the door repeat the procedure
backwards. Insert the door at an angle of about
15
°
into the hinge supports by pushing them
forward and downwards, so the hinges lock into
their slots (fig. 3). Check if the hinges are locked
into their respective slots.
Now open the door completely and turn the
removable locks into their original position. Close
the door slowly and check if they close properly
(fig. 4). If you have trouble closing the door,
check if the hinges are properly inserted into their
slots.
Attention
! Never let the hinge locks spring out,
as the springs are strong and may cause injuries.
