KLAXON Mobility Gmbh – ENG
KLICK Hybrid User's Manual (ENG) - rev.01 of 30.06.2018
12
•
Before use, check the lubrication of the chain and the manual transmission.
•
Before use, check that the manual transmission and all its drive elements are functioning correctly.
Have a KLAXON qualified technician overhaul the entire device at least once a year, and/or whenever a
malfunction occurs.
13.2 MALFUNCTIONS
If you encounter a malfunction during use of the KLICK device, contact KLAXON or of its authorised resellers.
Malfunction found
Possible cause
Corrective action
The device does not turn on (Electric
version)
The battery is empty
Recharge the battery
The battery is positioned
improperly
Check the position of the battery by removing it
and inserting it again, making sure that the
electrodes are inserted in the appropriate
spaces.
General problems
Contact an authorised KLAXON service centre
It vibrates excessively during use
Loose screws
Contact an authorised KLAXON service centre
The display lights up but the device does
not move
Disconnected plug
Contact an authorised KLAXON service centre
You have problems coupling the traction
unit to the connector
The connector is not adjusted
properly
Contact an authorised KLAXON service centre
You have problems attaching the
connector
There is dirt inside the coupling
seat in the crossbeam
Clean the surfaces of the seat in the crossbeam
and of the mounting system in the connector
You have problems attaching the
connector
The interlocking balls do not
retract when pulling the lever
Contact an authorised KLAXON service centre
Wheelchair front wheels touch the
ground
The Klick coupling is mounted too
low
Contact an authorised KLAXON service centre
KLICK is noisy when in use
The fender touches the wheel
while moving
Make sure your feet are in a position that does
not interfere with the fender of the device
Reposition the fender, putting it back into place.
The brake pads touch the disc
when reversing
Contact an authorised KLAXON service centre
13.3 POWER BATTERY (11 AH)
The POWER battery (48V and 11 Ah) is box-shaped and secured to the connection with a latching system (Figure 36).
On the top of the battery, there are markings along which some LEDs show the current charge level. Pressing the button, the LEDs
will show the approximate charge level, in four levels (20%-50%-80%-100%) and will automatically activate the battery, powering
the motor and the display (Figure 37). Use the same button to disable the battery (therefore the LEDs turn off).
The key, placed beside the battery, can be used to remove the entire unit from the device; by turning it, the battery is released and
it can be removed by pulling it forward and upward (Figures 38 and 39).
To charge the battery:
•
Turn the device off (by pressing and holding the “
POWER
” button);
•
Remove the battery by turning the key (Figures 38 and 39).
•
Remove the protection cap located on top of the battery (Figure 40).
•
Connect the battery charger's plug (Figure 41);
•
Connect the battery charger's plug to the 230V 50 Hz mains (Figure 34);
•
The two LED lights on the upper surface of the battery charger (Figure 35) show its status:
o
Red-red: charging;
o
Green-red: charging complete, fully charged battery.
•
When the battery is fully charged, first disconnect the plug from the mains socket and only then remove the plug from the
battery.
