44
EN
INSTALLATION
Before installation
• Connect the appliance to a power
outlet and perform a test of the
modes and functions.
• Make sure that all buttons are
working properly.
• Then disconnect the appliance
from the power supply again.
• Before installation, check that the
three rubber pads and the square
seal are on the appliance (see
picture).
Caution
: Moving parts can cause injuries. Be careful when testing the appliance.
Do not operate the appliance with the cover removed.
Step 1: Selecting the location and attaching the outdoor
appliance
Your air conditioner is designed for use in mobile homes. Check the roof of the
vehicle to see if it can support the load of the outdoor and indoor appliance
without additional support. Make sure that the mounting surface will not interfere
with existing structures inside. Once you have determined the location for the air
conditioner, you must either cut a reinforced and framed hole in the roof of the
vehicle (if there is not already a roof vent) or use existing vents.
Case A: If a roof vent is already present at the desired installation location for
the air conditioner, the following steps must be carried out:
1. Remove all screws securing the roof vent to the vehicle. Remove the vent and
any additional trim. Carefully remove the filler or sealant around the opening,
it should be clean for installation.
2. Seal all mounting screw holes of the old roof seal that are outside the floor
seal of the air conditioner.
