KisanKraft
®
AGRICULTURAL INTER-CULTIVATOR
KK-IC-250D,256D,215D
: +91.80.
6835 7800
Page 18 of 50
Running with low speed and low load before the engine gets hot. Avoid running with
high speed and full load, or low speed and no load.
•
Avoid running with overload.
During break-in period, the engine can't run with full load, but can run with 3000rpm
and 50% load.
•
Change Engine Oil Regularly.
After working for 20hrs, change the oil
when engine is still warm, otherwise it will
be difficult to drain the residual oil in the
engine.
Oil Bath Type Air Filter:
1. Check the oil level before operating.
2. Fill oil up to the upper limit. If oil is dirty, change it. Please use diesel to clean oil bath
element frequently, then dip the element in the oil and squeeze out extra.
2.
Running
WARNING
•
Be sure to operate the engine in a good, ventilated place in order to avoid exhaust
poisoning.
•
Avoid letting hands, body & clothes entangle in output shaft, belt pulley, V-type belt
pulley and other moving parts, so as to prevent from getting injured.
•
Stop the engine first and then maintain the movable parts and other parts around it.
Make sure there are no tools and sundries in the body of the engine before
operating.
2.1 Run engine for 5mins to warm up
NOTICE
•
The muffler becomes very hot during and immediately after operation. Don't touch it.
•
The air filter will inhale the air around itself when the engine works.
•
Don't let the hands, body and clothes approach the air filter to avoid injury.
2.2 After the engine becomes warm, put the speed lever on necessary position to run the
engine.
NOTICE
•
Be sure to use the speed lever to adjust the speed of engine.
Do not loosen the speed limit screw and fuel control screw; otherwise, the speed and
output of engine will be abnormal.
