KisanKraft
®
AGRICULTURAL INTER-CULTIVATOR
KK-IC-250D,256D,215D
: +91.80.
6835 7800
Page 30 of 50
! NOTE:
3.1. Hold and loose clutch rod two or three times, if find Inter-cultivator
still can’t engage
very well. Adjust the clutch cable.
3.2. If adjust many times still can’t solved problem, must be clutch worn out too much.
Then need take machine to service center to replace clutch Assy or clutch fork.
3.3. Don’t disassemble clutch by yourself or may be damaged clutch.
4. Throttle cable adjusting
When turn throttle lever, can’t increase, or decrease engine speed very well, need adjust
oil throttle cable according to SECTION FOUR.
! NOTE:
4.1 Turn the throttle lever two or three times, to see the function.
4.2 Throttle cable and cable head must use screw to fasten.
Debugging method of backshift gear and cable
When reverse of Inter-cultivator is abnormal, you should debug the backshift handlebar
and cable. As for the method, please refer to chapter3.
Attention: 1. Hold, unlock backshift handlebar twice to three times, which is to put into
gear. If the gear is not properly adjusted, please debug it until it is well done.
2. When driving the Inter-cultivator, please unlock backshift handlebar. After
finishing this, backshift gear should return to its original position immediately, and there
should not be abnormal collision noise in the gear box, otherwise, gear will be destroyed.
Debugging method of clutch cable
Due to friction plate abrasion, clutch fork abrasion, function of the clutch become poor
after a period of use. Therefore, you should debug the clutch cable. As for the debugging
method, please refer
Attention: 1. Hold, unlock the clutch handlebar for twice to three times. This is to check
working condition of clutch. If it is abnormal, you should
debug
the clutch.
2. If it is debugged for several times, and it is still in bad condition, it is certain
that clutch fork or friction plate is fretted severely. Therefore, you should change the
friction plate or clutch fork with new parts in the special maintenance station. Never move
clutch randomly in case of destroying the clutch and other parts.
Debugging method of throttle cable
When revolving the throttle switch and finding accelerating and decelerating function of
the diesel engine is not good, you should debug the throttle cable. As for the method,
please refer
