12
VISION 1460 INSTALL GUIDE
6-wire main harness
WHT
(–) Door/Trunk/Hood Input
YEL
(–) GWA Output
This input wire detects if a Door or the Trunk (or optionally, the Hood) is
opened. If opened while the 1460 is Armed, the siren will blast for up to 30
seconds. Wiring is shown below in
Fig-4
. Switches shown are open-ciruit (no
ground) when the door/trunk/hood is closed.
In situations where you need the WHT wire to connect to multiple loca-
tions, adding multiple diodes to the WHT wire can be tedious and prone to
error. We therefore recommend the optional
DSS-6
(1-to-6 splitter) to make
installation faster and error free. When using the DSS-6, please refer to its
product manual instead of
Fig-4
above.
Isolate each of your connections with diodes!
FIG-4: Door/Trunk wiring
If you connect the WHITE wire to the Trunk, be sure to connect the
GREEN wire of the 4-wire Harness (see page 8). This is especially im-
portant if the factory remote has a “Trunk Open” button. Otherwise, the
siren will go off when the trunk is opened while the 1460 is Armed.
IMPORTANT!
Feeds (–) 0v ground (500mA max.) while the 1460 is Armed. Connect GWA
to the YEL wire (“86”) of the
optional
896H-1B starter kill relay harness as
shown in
Fig-5
, and/or connect to the YEL wire of
optional
Luminator® LEDs.
OPTIONAL
IGNITION
SWITCH
OFF
ACC
ON
ST
PUR
cut
BLU
STARTER
FIG-5: Optional Starter Kill
YEL
896H-1B Relay
85
86
87
30
87a
YEL
