11
© 2015 KIRAMEK, INC.
11
6-wire main harness
This wire must be connected to the (+) 12v
Ignition line (showing 12v when IG switch is
turned on). The connection of this wire is vital
for triggering the siren when the ignition goes
on while Armed, for remote start compatibil-
ity, and for Manual Disarming.
NOTE
: If a factory or 3rd party remote starter is installed, be sure to con-
nect the 1460’s GRN/WHT wire to the vehicle’s Ignition wire as shown below:
GRN/WHT
(+)12v Ignition Input
The RED wire is the (+) 12v power input to the
1460. Be sure to connect this wire securely to
a
constant
12v source, such as the factory wire
attached to Pin-16 of the car’s OBD2 connector.
NEVER attach multiple high-current devices to
the same (+)12v connection point, as those devices make cause a downward
voltage spike that could cause the 1460 to malfunction.
RED
(+)12v System Power
BATTERY
RED
IGNITION
SWITCH
OFF
ACC
ON
ST
GRN/WHT
The BLACK wire is the (–) Ground input to the 1460.
Be sure to connect this wire securely to a good ground
source.
Most security system installation problems
result from a bad ground connection!
The easiest
connection may be to the factory wire behind Pin-4 of
the car’s OBD connector. Of course, you can connect to body metal or an
existing bolt (brush with steel wool first to make the best electrical contact),
or you can run a wire directly to the car’s Negative battery terminal if you
wish.
BLK
(–) System Ground
VEHICLE
GROUND
BLK
IGNITION
ENGINE
REMOTE STARTER
SWITCH
OFF
ACC
ON
IGNITION WIRE
IGNITION WIRE
to vehicle
ST
GRN/WHT