Kioti DK4210(C)HSE, Manual

Page: 65 / 214

4
4
-
11 Function description and operating tips
how to deactivate pto cruise
depress the brake pedal or turn off
the pto cruise switch to deactivate
the function.
if the pto cruise is deactivated by
depressing the brake pedal with the
pto cruise switch in the “on” posi-
tion, pressing the res (+) switch
once resumes the function to the
previous state.
important
the pto cruise is not deac-
tivated when depressing one
of the brake pedals with the
brake pedals disconnected
from each other.
•
dpF regeneration switch
(1) dpF regeneration switch
(a) activation (b) deactivation
deactivation (lower portion
oF switch)
do not press the deactivation portion
of the switch while the regeneration
process is activated.
however, the switch can be set to
the deactivation position to stop the
regeneration process in emergency.
11
A A
B B
d21o436a
activation (upper button)
perform the following procedure
when the regeneration warning lamp
comes on :
1. park the vehicle on level ground
2. start the engine and run the en-
gine at the idle speed.
3. depress the brake pedal and lock
it in place.
4. do not depress the clutch pedal.(if
equipped)
5. put the range shift lever on the
neutral position
6. run the engine 3 to 4 minutes.
then, press the regeneration button
over 2 second.
note
the regeneration underway
lamp is turned on when the dpF
temperature reaches a certain
temperature.
•
7. the regeneration underway lamp
blinks after the regeneration warn-
ing lamp goes off.
wait for approx. 30 to 40 minutes
until the regeneration process is
completed.
TD210-미국법인향-DK4210,4710,5310,60111 11 2020-11-18 오후 2:34:48