Kioti DK4210(C)HSE, Manual

Page: 169 / 214

57
7
-
17
maintenance
8. run the start motor for approx.
10 seconds to distribute oil to
each part of the engine.
9. run the engine for approx. 5 min-
utes and check for proper opera-
tion through the engine oil warning
lamp. then, stop the engine. (it is
normal that the oil warning lamp is
off while the engine running)
10. check the engine oil level again
with the oil dipstick. if the level is
low, add more oil.
NOTE
the engine oil filter should be
replaced when changing the en-
gine oil.
•
IMPORTANT
Use only specified engine oil
and kIOTI genuine filter to
insure smooth operation and
durability of the engine.
•
WARNING
The engine oil is very hot while
the engine is running or right
after the engine is stopped. Be
careful not to be burnt.
Avoid oil contact while chang-
ing or adding engine oil and
wear eye protection to prevent
eye contact.
Prolonged and repeated con-
tact with the engine oil may
cause skin disorders and
skin cancer. If skin contact is
made, wash thoroughly with
soap or hand cleaner as soon
as possible.
keep the used oil out of reach
of children.
•
•
•
•
CAUTION
To avoid injury:
Be sure to stop the engine before
changing the fluid or replacing
the filter.
Check the engine oil level before
every operation of the tractor. If
the engine oil is insufficient, the
engine can be damaged, and this
is not covered by warranty. Be
sure to add the engine oil when
its level is below the lower limit
of the oil dipstick.
Do not dispose of used oil and
oil filter into drainage and other
places not designated by regula-
tions. Observe applicable regula-
tions when disposing used oil
and filters.
•
•
•
TD210-미국법인향-DK4210,4710,5310,60117 17 2019-09-18 오후 4:53:32